bare/gpt-6.1-sol / tier-2-offset-handle-mug
success tier 2
bare (gpt 6.1 sol)
render
$fn = 160;
// 単位: mm
outer_diameter = 80;
inner_diameter = 70;
mug_height = 90;
bottom_thickness = 6;
handle_opening_height = 30;
handle_opening_width = 25;
handle_depth = 10;
handle_outer_radius = 32;
handle_back_x = outer_diameter / 2 - 2; // 本体へ2mm食い込ませる
handle_inner_offset = 4;
handle_center_z = mug_height / 2;
epsilon = 0.1;
// +X側を向く半円。直線部分は x=0。
module half_circle_2d(radius) {
intersection() {
circle(r = radius);
translate([0, -radius])
square([radius, 2 * radius]);
}
}
// 外側は半円、内側の開口は幅25mm・高さ30mmのD字形。
module handle_profile_2d() {
difference() {
half_circle_2d(handle_outer_radius);
translate([handle_inner_offset, 0])
scale([
handle_opening_width,
handle_opening_height / 2
])
half_circle_2d(1);
}
}
// XZ平面に配置し、Y方向に厚みを付ける。
module handle() {
translate([handle_back_x, 0, handle_center_z])
rotate([90, 0, 0])
linear_extrude(height = handle_depth, center = true)
handle_profile_2d();
}
render(convexity = 10)
difference() {
union() {
cylinder(d = outer_diameter, h = mug_height);
handle();
}
// 上面まで貫通する空洞。底は6mm残す。
translate([0, 0, bottom_thickness])
cylinder(
d = inner_diameter,
h = mug_height - bottom_thickness + epsilon
);
} パラメータ (10) —
スライダを動かすと openscad-wasm で再レンダリング
prompt
OpenSCAD で、向きが指定されたマグカップを作ってください。 本体: - 外径 80mm、内径 70mm(肉厚 5mm)、高さ 90mm の円筒形マグ - 底面の厚みは 6mm - 内側は飲み物を入れられるよう中空 取手(handle): - マグの **+X 軸方向の側面のみ** に付ける(他の方向には付けない) - 取手は D 字形状(外側が半円、本体側が直線)で、本体外周にしっかり接続する - 取手の内側の空間は高さ 30mm × 幅 25mm(指 3 本ぐらい入る) - 取手はマグの高さ方向の中央付近に付ける - 本体と取手は確実に union され、マニフォールド(隙間や宙吊りなし)を保つ 完成したコード全体を ```openscad ... ``` のフェンスで囲んで出力してください。コードのみで、追加の説明は不要です。