bare-xhigh/gpt-6-sol / tier-2-offset-handle-mug
success tier 2
bare (gpt 6 sol)
render
$fn = 128;
mug_outer_d = 80;
mug_inner_d = 70;
mug_height = 90;
bottom_thickness = 6;
handle_depth = 14; // Y方向の厚み
handle_z = mug_height / 2;
// 取手の外形:本体側が直線、外側が半円
outer_flat_x = mug_outer_d / 2 - 3; // 本体に3mm食い込ませる
outer_arc_x = mug_outer_d / 2 + 11;
outer_radius = 24;
// 内側の空間:高さ30mm、幅25mm
inner_radius = 15;
inner_arc_x = mug_outer_d / 2 + 12;
inner_flat_x = inner_arc_x - (25 - inner_radius);
module d_profile(flat_x, arc_x, radius, center_z) {
polygon(points = concat(
[[flat_x, center_z - radius]],
[for (a = [-90:3:90])
[arc_x + radius * cos(a),
center_z + radius * sin(a)]],
[[flat_x, center_z + radius]]
));
}
module mug_body() {
difference() {
cylinder(d = mug_outer_d, h = mug_height);
translate([0, 0, bottom_thickness])
cylinder(
d = mug_inner_d,
h = mug_height - bottom_thickness + 1
);
}
}
module handle() {
rotate([90, 0, 0])
linear_extrude(height = handle_depth, center = true)
difference() {
d_profile(outer_flat_x, outer_arc_x,
outer_radius, handle_z);
d_profile(inner_flat_x, inner_arc_x,
inner_radius, handle_z);
}
}
union() {
mug_body();
handle();
} パラメータ (7) —
スライダを動かすと openscad-wasm で再レンダリング
prompt
OpenSCAD で、向きが指定されたマグカップを作ってください。 本体: - 外径 80mm、内径 70mm(肉厚 5mm)、高さ 90mm の円筒形マグ - 底面の厚みは 6mm - 内側は飲み物を入れられるよう中空 取手(handle): - マグの **+X 軸方向の側面のみ** に付ける(他の方向には付けない) - 取手は D 字形状(外側が半円、本体側が直線)で、本体外周にしっかり接続する - 取手の内側の空間は高さ 30mm × 幅 25mm(指 3 本ぐらい入る) - 取手はマグの高さ方向の中央付近に付ける - 本体と取手は確実に union され、マニフォールド(隙間や宙吊りなし)を保つ 完成したコード全体を ```openscad ... ``` のフェンスで囲んで出力してください。コードのみで、追加の説明は不要です。