bare-xhigh/gpt-6-luna / tier-2-offset-handle-mug
success tier 2
bare (gpt 6 luna)
render
$fn = 128;
outer_diameter = 80;
inner_diameter = 70;
mug_height = 90;
bottom_thickness = 6;
handle_opening_width = 25;
handle_opening_height = 30;
handle_wall = 5;
handle_depth = 12;
handle_inner_x = 42;
handle_center_z = mug_height / 2;
handle_arc_steps = 48;
// D-shaped profile: straight back with a semicircular outer end.
function d_profile_points(x, zc, w, h, steps) =
let(
r = h / 2,
straight = w - r
)
concat(
[[x, zc + r], [x + straight, zc + r]],
[
for (i = [1:steps])
let(a = 90 - 180 * i / steps)
[x + straight + r * cos(a), zc + r * sin(a)]
],
[[x, zc - r]]
);
module mug_body() {
difference() {
cylinder(h = mug_height, d = outer_diameter);
translate([0, 0, bottom_thickness])
cylinder(h = mug_height, d = inner_diameter);
}
}
module handle_profile() {
difference() {
offset(r = handle_wall)
polygon(points = d_profile_points(
handle_inner_x,
handle_center_z,
handle_opening_width,
handle_opening_height,
handle_arc_steps
));
polygon(points = d_profile_points(
handle_inner_x,
handle_center_z,
handle_opening_width,
handle_opening_height,
handle_arc_steps
));
}
}
module mug_handle() {
rotate([90, 0, 0])
linear_extrude(height = handle_depth, center = true, convexity = 10)
handle_profile();
}
union() {
mug_body();
mug_handle();
} パラメータ (10) —
スライダを動かすと openscad-wasm で再レンダリング
prompt
OpenSCAD で、向きが指定されたマグカップを作ってください。 本体: - 外径 80mm、内径 70mm(肉厚 5mm)、高さ 90mm の円筒形マグ - 底面の厚みは 6mm - 内側は飲み物を入れられるよう中空 取手(handle): - マグの **+X 軸方向の側面のみ** に付ける(他の方向には付けない) - 取手は D 字形状(外側が半円、本体側が直線)で、本体外周にしっかり接続する - 取手の内側の空間は高さ 30mm × 幅 25mm(指 3 本ぐらい入る) - 取手はマグの高さ方向の中央付近に付ける - 本体と取手は確実に union され、マニフォールド(隙間や宙吊りなし)を保つ 完成したコード全体を ```openscad ... ``` のフェンスで囲んで出力してください。コードのみで、追加の説明は不要です。