bare-max/gpt-6.1-sol / tier-2-offset-handle-mug
success tier 2
bare (gpt 6.1 sol)
render
$fn = 160;
outer_diameter = 80;
inner_diameter = 70;
mug_height = 90;
bottom_thickness = 6;
handle_open_width = 25;
handle_open_height = 30;
handle_wall = 5;
handle_depth = 10;
handle_overlap = 3;
handle_root_x = outer_diameter / 2 - handle_overlap;
handle_center_z = mug_height / 2;
epsilon = 0.1;
// 本体側が直線、外側の円弧が半円の D 字断面。
module d_profile(width, height) {
radius = height / 2;
straight_length = width - radius;
intersection() {
union() {
translate([0, -radius])
square([straight_length, height]);
translate([straight_length, 0])
circle(r = radius);
}
translate([0, -radius])
square([width, height]);
}
}
module mug_body() {
difference() {
cylinder(d = outer_diameter, h = mug_height);
translate([0, 0, bottom_thickness])
cylinder(
d = inner_diameter,
h = mug_height - bottom_thickness + epsilon
);
}
}
module mug_handle() {
// XZ 平面に配置し、+X 側の外壁へ 3mm 食い込ませる。
translate([handle_root_x, 0, handle_center_z])
rotate([90, 0, 0])
linear_extrude(
height = handle_depth,
center = true,
convexity = 10
)
difference() {
d_profile(
handle_open_width + 2 * handle_wall,
handle_open_height + 2 * handle_wall
);
translate([handle_wall, 0])
d_profile(
handle_open_width,
handle_open_height
);
}
}
union() {
mug_body();
mug_handle();
} パラメータ (10) —
スライダを動かすと openscad-wasm で再レンダリング
prompt
OpenSCAD で、向きが指定されたマグカップを作ってください。 本体: - 外径 80mm、内径 70mm(肉厚 5mm)、高さ 90mm の円筒形マグ - 底面の厚みは 6mm - 内側は飲み物を入れられるよう中空 取手(handle): - マグの **+X 軸方向の側面のみ** に付ける(他の方向には付けない) - 取手は D 字形状(外側が半円、本体側が直線)で、本体外周にしっかり接続する - 取手の内側の空間は高さ 30mm × 幅 25mm(指 3 本ぐらい入る) - 取手はマグの高さ方向の中央付近に付ける - 本体と取手は確実に union され、マニフォールド(隙間や宙吊りなし)を保つ 完成したコード全体を ```openscad ... ``` のフェンスで囲んで出力してください。コードのみで、追加の説明は不要です。