bare-high/gpt-6-luna / tier-2-offset-handle-mug
success tier 2
bare (gpt 6 luna)
render
$fn = 128;
// マグ本体
cup_outer_diameter = 80;
cup_inner_diameter = 70;
cup_height = 90;
bottom_thickness = 6;
// 取手
handle_thickness = 12;
handle_center_z = cup_height / 2;
outer_chord_x = 37;
outer_radius = 35;
// 取手の内側空間:幅25mm × 高さ30mm
opening_left_x = 42;
opening_round_start_x = 52;
opening_radius = 15;
module cup_body() {
difference() {
cylinder(d = cup_outer_diameter, h = cup_height);
translate([0, 0, bottom_thickness])
cylinder(
d = cup_inner_diameter,
h = cup_height - bottom_thickness + 1
);
}
}
module handle_profile_2d() {
difference() {
polygon(points = concat(
[[outer_chord_x, -outer_radius]],
[
for (a = [-90 : 2 : 90])
[
outer_chord_x + outer_radius * cos(a),
outer_radius * sin(a)
]
],
[[outer_chord_x, outer_radius]]
));
polygon(points = concat(
[[opening_left_x, -opening_radius]],
[[opening_round_start_x, -opening_radius]],
[
for (a = [-90 : 2 : 90])
[
opening_round_start_x + opening_radius * cos(a),
opening_radius * sin(a)
]
],
[[opening_left_x, opening_radius]]
));
}
}
union() {
cup_body();
translate([0, 0, handle_center_z])
rotate([90, 0, 0])
linear_extrude(height = handle_thickness, center = true)
handle_profile_2d();
} パラメータ (10) —
スライダを動かすと openscad-wasm で再レンダリング
prompt
OpenSCAD で、向きが指定されたマグカップを作ってください。 本体: - 外径 80mm、内径 70mm(肉厚 5mm)、高さ 90mm の円筒形マグ - 底面の厚みは 6mm - 内側は飲み物を入れられるよう中空 取手(handle): - マグの **+X 軸方向の側面のみ** に付ける(他の方向には付けない) - 取手は D 字形状(外側が半円、本体側が直線)で、本体外周にしっかり接続する - 取手の内側の空間は高さ 30mm × 幅 25mm(指 3 本ぐらい入る) - 取手はマグの高さ方向の中央付近に付ける - 本体と取手は確実に union され、マニフォールド(隙間や宙吊りなし)を保つ 完成したコード全体を ```openscad ... ``` のフェンスで囲んで出力してください。コードのみで、追加の説明は不要です。