vibe-openscad

tier-2-hex-bolt / gemma-4-31b-it

2 run / 累計 14.6s / 累計 $0

gemini gemma 4 31b bare-think-off

bare (provider default effort)

run detail →
render
bare render of tier-2-hex-bolt
loading STL…
success 7.3s · 173/215t · $0
SCAD (22 lines)
// M8 Hex Bolt Parameters
across_flats = 13;
head_height = 5.3;
shank_diameter = 8;
shank_length = 30;

// Calculate the circumradius of the hexagon from the across-flats distance
// r = s / (2 * cos(30°)) = s / sqrt(3)
head_radius = across_flats / sqrt(3);

$fn = 64;

union() {
    // Head: Hexagonal prism
    // Positioned such that the bottom face is at z=0
    cylinder(h = head_height, r = head_radius, $fn = 6);

    // Shank: Cylindrical shaft
    // Extends from z=0 down to z = -shank_length
    translate([0, 0, -shank_length])
    cylinder(h = shank_length, d = shank_diameter);
}
パラメータ (4) —
スライダを動かすと openscad-wasm で再レンダリング

prompt

OpenSCAD で、規格に準じた M8 サイズの六角ボルトを作ってください。
ねじ山自体は省略してよく、円柱のシャンクで構いません。

寸法は以下に従ってください:
- 頭部は六角柱で、対辺距離(across-flats)13mm、高さ 5.3mm
- シャンク(軸部)は直径 8mm、長さ 30mm の円柱
- ボルト全体の中心軸は +Z 軸方向
- 頭部の底面が原点(z=0)に来るように配置し、シャンクは z<0 側へ伸ばす

完成したコード全体を ```openscad ... ``` のフェンスで囲んで出力してください。コードのみで、追加の説明は不要です。

variant: thinking

offnot run
—
adaptivenot run
—
dynamic (default) success →
dynamic
7.3s · 173/215t · $0
SCAD (22 lines)
// M8 Hex Bolt Parameters
across_flats = 13;
head_height = 5.3;
shank_diameter = 8;
shank_length = 30;

// Calculate the circumradius of the hexagon from the across-flats distance
// r = s / (2 * cos(30°)) = s / sqrt(3)
head_radius = across_flats / sqrt(3);

$fn = 64;

union() {
    // Head: Hexagonal prism
    // Positioned such that the bottom face is at z=0
    cylinder(h = head_height, r = head_radius, $fn = 6);

    // Shank: Cylindrical shaft
    // Extends from z=0 down to z = -shank_length
    translate([0, 0, -shank_length])
    cylinder(h = shank_length, d = shank_diameter);
}