vibe-openscad

tier-1-cube-with-hole / gemini-3.1-flash-lite

6 run / 累計 8.7s / 累計 $0.0015

gemini flash-lite 3.1 bare

bare (provider default effort)

run detail →
render
bare render of tier-1-cube-with-hole
loading STL…
success 1.0s · 68/50t · <$0.0001
SCAD (4 lines) 
difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 50, d = 20, center = true);
}

prompt

OpenSCAD で、50mm 角の立方体の中央に、直径 20mm の貫通穴を z 軸方向に開けたモデルを作成してください。

完成したコード全体を ```openscad ... ``` のフェンスで囲んで出力してください。コードのみで、追加の説明は不要です。

variant: thinking

off success →
off
0.9s · 68/50t · <$0.0001
SCAD (4 lines) 
difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 50, d = 20, center = true);
}
adaptivenot run
—
dynamic (default) success →
dynamic
1.0s · 68/50t · <$0.0001
SCAD (4 lines) 
difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 50, d = 20, center = true);
}

iteration: iter-png

i1 success →
iter 1
2.1s · 1250/59t · $0.0004
diff vs bare: +2/-0 
+ $fn = 100;
+ 
  difference() {
      cube([50, 50, 50], center = true);
      cylinder(h = 50, d = 20, center = true);
  }
SCAD (6 lines) 
$fn = 100;

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 50, d = 20, center = true);
}
i2 success →
iter 2
1.7s · 1259/59t · $0.0004
diff vs i1: +1/-1 
  $fn = 100;
  
  difference() {
      cube([50, 50, 50], center = true);
-     cylinder(h = 50, d = 20, center = true);
+     cylinder(h = 51, d = 20, center = true);
  }
SCAD (6 lines) 
$fn = 100;

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 51, d = 20, center = true);
}
i3 success →
iter 3
1.8s · 1259/59t · $0.0004
diff vs i2: +1/-1 
  $fn = 100;
  
  difference() {
      cube([50, 50, 50], center = true);
-     cylinder(h = 51, d = 20, center = true);
+     cylinder(h = 50, d = 20, center = true);
  }
SCAD (6 lines) 
$fn = 100;

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 50, d = 20, center = true);
}