tier-1-cube-with-hole / `claude-sonnet-5`

7 run / 累計 15.6s / 累計 $0.0093

claude sonnet 5 bare

bare (provider default effort)

render

loading STL…

success 1.8s · 111/60t · $0.0008

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 100);
}

```openscad
difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 100);
}
```

OpenSCAD で、50mm 角の立方体の中央に、直径 20mm の貫通穴を z 軸方向に開けたモデルを作成してください。

完成したコード全体を ```openscad ... ``` のフェンスで囲んで出力してください。コードのみで、追加の説明は不要です。

low success →

1.7s · 111/60t · $0.0008

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 100);
}

mediumnot run

—

high (default) success →

1.8s · 111/60t · $0.0008

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 100);
}

max success →

3.3s · 111/238t · $0.0026

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 100);
}

xhigh success →

1.7s · 111/57t · $0.0008

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center=true);
    cylinder(h=60, d=20, center=true, $fn=100);
}

off success →

1.8s · 111/60t · $0.0008

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 100);
}

adaptive (default) success →

3.3s · 111/238t · $0.0026

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 100);
}

dynamicnot run

—