tier-1-cube-with-hole / `claude-opus-4-20250514`

5 run / 累計 13.0s / 累計 $0.0646

claude opus 4 2025-05-14 bare

bare (provider default effort)

render

loading STL…

success 3.1s · 104/55t · $0.0057

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 50);
}

OpenSCAD で、50mm 角の立方体の中央に、直径 20mm の貫通穴を z 軸方向に開けたモデルを作成してください。

完成したコード全体を ```openscad ... ``` のフェンスで囲んで出力してください。コードのみで、追加の説明は不要です。

off (default) success →

3.1s · 104/55t · $0.0057

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 50);
}

adaptivenot run

—

dynamicnot run

—

i1 success →

2.1s · 908/55t · $0.0177

diff vs bare: +0/-0

  difference() {
      cube([50, 50, 50], center = true);
      cylinder(h = 60, d = 20, center = true, $fn = 50);
  }

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 50);
}

i2 success →

2.5s · 908/55t · $0.0177

diff vs i1: +0/-0

  difference() {
      cube([50, 50, 50], center = true);
      cylinder(h = 60, d = 20, center = true, $fn = 50);
  }

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 50);
}

i3 success →

2.2s · 908/55t · $0.0177

diff vs i2: +0/-0

  difference() {
      cube([50, 50, 50], center = true);
      cylinder(h = 60, d = 20, center = true, $fn = 50);
  }

SCAD (4 lines)

difference() {
    cube([50, 50, 50], center = true);
    cylinder(h = 60, d = 20, center = true, $fn = 50);
}